IKEA MHIN2K Manual do Utilizador descarregar pdf (Página 11)

The graphic above represents the rating

plate of the appliance (without serial num-

ber which is generated dynamically during

the production process), which is located at

its underneath surface of the casing.

Dear Customer, please apply here aside

the sticker you can find in the dedicate

plastic bag inserted inside the hob packag-

ing. This will allow us to assist you better, by

identifying precisely your hob, in case you

will need in future our assistance. Thank you

for your help!

Installation

Manufacturer is not responsible for any in-

jury to persons and pets or damage to

property caused by failure to comply fol-

lowing requirements.

Caution! To proceed with the

installation refer to the assembly

instructions.

Warning! Installation process must

follow the laws, ordinances, directives

and standards (electrical safety rules and

regulations, proper recycling in accordance

with the regulations, etc.) in force in the

country of use!

Warning! The appliance must be

earthed!

Warning! Risk of injury from electrical

current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of

voltage.

• Loose and inappropriate plug and socket

connections can make the terminal over-

heat.

• Have the clamping connections correctly

installed.

• Use strain relief clamp on cable.

• Follow the connection diagram.

Important! You must observe the minimum

distances to other appliances and furniture

cabinets or other units according to

Assembly Instruction.

If there is no oven beneath the hob insert a

dividing panel at a minimum distance of 20

mm from the bottom of the hob.

Protect the cut surfaces of the worktop

against moisture using a suitable sealant in-

cluded in the product in fitting bag. The

sealant seals the appliance to the work top

with no gap. Do not use silicon sealant be-

tween the appliance and the worktop.

Avoid installing the appliance next to doors

and under windows as hot cookware may

be knocked off the rings when doors and

windows are opened.

Only an authorized service engineer can in-

stall, connect or repair this appliance. Use

only original spare parts.

Electrical connection

Before connecting, check that the nominal

voltage of the appliance stated on the rat-

ing plate, corresponds to the available sup-

ply voltage. Also, check the power rating of

the appliance and ensure that the wire is

suitably sized to suit the appliance power

rating (refer to the Technical data chapter).

The rating plate is located on the lower cas-

ing of the hob.

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

Comentários a estes Manuais

Sem comentários