
seconds. For the subsequent few seconds
the display shows the software version.
After the software version goes off, the
display shows and "12:00". "12"
flashes.
1. Turn the knob for the temperature /
microwave power right or left to set the
current hour.
2. Press to confirm or the set hour will
be saved automatically after 5 seconds.
The display shows and the set hour.
"00" flashes.
3. Turn the knob for the temperature /
microwave power right or left to set the
current minutes
4. Press to confirm or the set minutes
will be saved automatically after 5
seconds.
The display shows the new time.
Changing the time
You can change the time of day only when
the oven is in standby mode.
Press again and again until the symbol
flashes in the display.
To set a new time, refer to "Setting the
time".
Preheating
Preheat the empty appliance before first
use. For microwaves you can leave only
wire shelves inside. The microwave bottom
glass plate must be removed.
1. Set the function
and the maximum
temperature. Do not add the microwave
function.
2. Let the appliance operate for 1 hour.
Accessories can become hotter than usual.
The appliance can emit an odour and
smoke. This is normal. Make sure that the
airflow in the room is sufficient.
Using the Mechanical child lock
The appliance has the child lock installed
and activated. It is below the control panel
on the right side.
To open the oven door with the child lock
installed, pull the child lock handle up as
shown in the picture.
Close the oven door without pulling the
child lock.
To remove the child lock, open the oven
door and remove the child lock with the torx
key. The torx key is in the oven fitting bag.
Screw back the screw into the hole after
removing the child lock.
Daily use
Warning! Refer to Safety
chapters.
ENGLISH 11
Comentários a estes Manuais